Published Documents Documents Under Development Government Documents
Clicking the designated number listed under the "Record #" category displays the full contents of a particular entry.
Items found: 188
Record # | Source (e.g. developer/organization) | Acronym (e.g. ISO, IEC) | Identifier (e.g. document designation number) | Title of document | Scope/description | Keywords | Type of Document | Issue area(s) this applies to | Primary category that this applies to | Intended stakeholders | LastModif |
---|---|---|---|---|---|---|---|---|---|---|---|
225 | International Electrotechnical Commission | IEC | 62607-6-13 | Nanomanufacturing - Key control characteristics - Part 6-13: Graphene powder - Oxygen functional group content: Boehm titration method | establishes a standardized method to determine the chemical key control characteristic - oxygen... | Boehm titration graphene oxide | e. Specification | Measurement and Characterizations | Energy e.g. Energy storage, energy efficiency | 2021-10-08 | |
223 | International Electrotechnical Commission | IEC | 62607-6-1 | Nanomanufacturing - Key control characteristics - Part 6-1: Graphene-based material - Volume resistivity: four probe method | establishes a standardized method to determine the electrical key control characteristic – volume... | volume resistivity graphene powder oxide reduced | e. Specification | Measurement and Characterizations | Energy e.g. Energy storage, energy efficiency | 2021-10-08 | |
222 | International Electrotechnical Commission | IEC | 62607-5-3 | Nanomanufacturing - Key control characteristics - Part 5-3: Thin-film organic/nano electronic devices – Measurements of charge carrier concentration | Specifies sample structures for evaluating a wide range of charge carrier concentration in... | van der Pauw; carrier concentration | e. Specification | Measurement and Characterizations | Energy e.g. Energy storage, energy efficiency | 2021-10-01 | |
221 | International Electrotechnical Commission | IEC | 62607-4-8 | Nanomanufacturing - Key control characteristics - Part 4-8: Nano-enabled electrical energy storage - Determination of water content in electrode nanomaterials, Karl Fischer method | Specifies a test method for the determination of water content in electrode nanomaterials for... | e. Specification | Measurement and Characterizations | Energy e.g. Energy storage, energy efficiency | 2021-09-28 | ||
220 | International Electrotechnical Commission | IEC | 62607-4-7 | Nanomanufacturing - Key control characteristics - Nano-enabled electrical energy storage - Determination of magnetic impurities in anode nanomaterials, ICP-OES method | Provides a method for the determination of magnetic impurities in anode nanomaterials for energy... | Energy e.g. Energy storage, energy efficiency | 2021-09-28 | ||||
219 | International Electrotechnical Commission | IEC | 62607-4-6 | Nanomanufacturing - Key control characteristics - Nano-enabled electrical energy storage. Determination of carbon content for nano-enabled electrode materials, infrared absorption method | Provides a method for determination of carbon content of nano-electrode materials by infrared... | e. Specification | Measurement and Characterizations | Energy e.g. Energy storage, energy efficiency | 2021-09-28 | ||
215 | International Electrotechnical Commission | IEC | 62607-3-3 | Nanomanufacturing - Key control characteristics - Part 3-3: Luminescent nanomaterials - Determination of fluorescence lifetime of semiconductor quantum dots using time correlated single photon counting (TCSPC) | provides a method for determining the fluorescence lifetime of semiconductor quantum dots (QDs)... | quantum dots; QD; semiconductor; fluorescence | a. Standard | Measurement and Characterizations | Energy e.g. Energy storage, energy efficiency | 2021-09-10 | |
3 | International Electrotechnical Commission | IEC | 62607-3-1 | Nanomanufacturing - Key control characteristics - Part 3-1: Luminescent nanomaterials - Quantum efficiency | Specifies the procedures to be followed and precautions observed when performing reproducible... | Quantum efficiency, quantum dots, nanoparticles, nanophosphors, nanocrystals | a. Standard | Measurement and Characterizations | Energy e.g. Energy storage, energy efficiency | End use product manufacturers in the lighting, electronics (touch screens), renewable energy and... | 2017-01-18 |
218 | International Electrotechnical Commission | IEC | 62607-2-4 | Nanomanufacturing - Key control characteristics - Part 2-4: Carbon nanotube materials - Test methods for determination of resistance of individual carbon nanotubes | Specifies the test method for determining the resistivity and the contact resistance... | carbon nanotubes; CNT, resistivity, contact resistance | e. Specification | Measurement and Characterizations | Energy e.g. Energy storage, energy efficiency | 2021-09-28 | |
25 | International Electrotechnical Commisssion | IEC | 62607-2-1 | Nanomanufacturing - Key control characteristics - Part 2-1: Carbon nanotube materials - Film resistance | Provides a standardized method for categorizing a grade of commercial carbon nanotubes in terms... | film resistance, key control characteristics, nanotube, carbon nanotubes | e. Specification | Measurement and Characterizations Performance Methods | Energy e.g. Energy storage, energy efficiency | Carbon nanotube suppliers; Producers of nano-electrotechnical enabled products or systems, e.g.... | 2014-02-28 |
217 | International Electrotechnical Commission | IEC | 62565-4-2 | Nanomanufacturing - Material specifications - Part 4-2: Luminescent nanomaterials - Detail specification for general lighting and display applications | specifies the essential general and optical requirements of monodisperse luminescent... | nanomanufacturing; luminescent; nanomaterials; quantum dots; monodisperse | e. Specification | Material Specifications | Energy e.g. Energy storage, energy efficiency | 2021-09-28 | |
216 | International Electrotechnical Commission | IEC | 62565-4-1 | Nanomanufacturing - Key control characteristics - Part 4-1: Luminescent nanomaterials - Blank detail specification | Establishes a blank detail specification and format for listing essential optical and certain... | luminescent; nanomaterials; quantum dots; nanophosphors | e. Specification | Material Specifications | Energy e.g. Energy storage, energy efficiency | 2021-09-28 | |
15 | International Electrotechnical Commisssion | IEC | 62565-2-1 | Nanomanufacturing - Material specifications - Part 2-1: Single-wall carbon nanotubes - Blank detail specification | IEC/PAS 62565-2-1:2011(E) establishes a blank detail specification for the essential electrical... | Carbon nanotubes, blank detail specification, single-wall, CNT, SWCNT | e. Specification | Measurement and Characterizations Material Specifications Performance Methods | Energy e.g. Energy storage, energy efficiency | Suppliers and end users of carbon nanotubes intended for use in electrical and electronic... | 2014-02-28 |
31 | International Organization for Standardization | ISO | 29701 | Nanotechnologies — Endotoxin test on nanomaterial samples for in vitro systems — Limulus amebocyte lysate (LAL) test | This International Standard describes the application of a test using Limulus amebocyte lysate... | a. Standard | Health, Safety, and Environment | General Industry/Manufacturing | 2014-02-28 | ||
189 | International Organization for Standardization | ISO | 22455 | Nanotechnologies - High Throughput Screening Method For Nanoparticles Toxicity Using 3D Model Cells | This proposal is to define a reliable and repeatable high throughput screening method to evaluate... | nanoparticles, cytoxicity, 3D cells, screening assays | a. Standard | Health, Safety, and Environment | 2022-01-14 | ||
200 | International Organization for Standardization | ISO | 21363 | Nanotechnologies — Measurements of particle size and shape distributions by transmission electron microscopy | This document specifies how to capture, measure and analyse transmission electron microscopy... | particle size, shape, nanoparticles, carbon nanotubes, gold nanoparticles, titania | a. Standard | Measurement and Characterizations | 2021-08-17 | ||
190 | International Organization for Standardization | ISO | 21361 | Nanotechnologies -- Method to quantify air concentrations of carbon black and amorphous silica in the nanoparticle size range in a mixed dust manufacturing environment | This document provides guidelines to quantify and identify air concentration (number of... | carbon black; amorphous silica, industrial, collection, characterization, TEM | a. Standard | Measurement and Characterizations Health, Safety, and Environment | General Industry/Manufacturing | 2019-06-14 | |
149 | International Organization for Standardization | ISO | 21237 | Nanotechnologies — Air filter media containing polymeric nanofibres — Specification of characteristics and measurement methods | This document specifies the characteristics to be measured of air filter media containing... | nano-fibres, filtration | a. Standard | Material Specifications | 2021-08-12 | ||
148 | International Organization for Standardization | ISO | 21236-1 | Nanotechnologies — Clay nanomaterials — Part 1: Specification of characteristics and measurement methods for layered clay nanomaterials | This document specifies characteristics to be measured of layered clay nanomaterials in powder... | clay nanomaterials, nanostructured materials, physical, chemical properties | a. Standard | Material Specifications | 2021-08-12 | ||
145 | International Organization for Standardization | ISO | 20814 | Nanotechnologies — Testing the photocatalytic activity of nanoparticles for NADH oxidation | This document specifies a method for the measurement of the photocatalytic activity (PCA) of... | Photocatalytic activity; titanium dioxide, environmental media, phototoxicity | a. Standard | Health, Safety, and Environment | Chemicals e.g. pesticides, pharmaceuticals, paints, basic chemicals | Nanomaterial manufacturers, nanomaterial users (cosmetics, pharmaceuticals, composite material,... | 2021-08-12 |
136 | International Organization for Standardization | ISO | 19716 | Nanotechnologies -- Characterization of cellulose nanocrystals -- Particle morphology, purity and surface properties | This Technical Report reviews commonly used methods for the characterization of cellulose... | Cellulose nanocrystals, CNCs, measurement methods, sample preparation | a. Standard | Measurement and Characterizations | 2016-06-07 | ||
59 | International Organization for Standardization | ISO | 19601 | Aerosol generation for NOAA (Nano-objects, and their aggregates and agglomerates) air exposure studies | This technical report reviews the practice of aerosolization of NOAA (nano-objects and their... | Nano-objects, and their aggregated and agglomerates greater than 100 nm (NOAA), in vivo, in vitro, t | a. Standard | Health, Safety, and Environment | 2017-08-29 | ||
135 | International Organization for Standardization | ISO | 19590 | Detection and sizing of nanoparticles in aqueous media via single particle inductively coupled plasma mass spectrometry (ICP-MS) | This ISO TS specifies a test method for the detection and characterisation of nanoparticles in... | nanoparticles, aqeuous solutions, ICP-MS, particle concentration | a. Standard | Health, Safety, and Environment | 2017-06-15 | ||
18 | International Organization for Standardization | ISO | 19007 | Nanotechnologies - In Vitro MTS Assay For Measuring The Cytotoxic Effect Of Nanoparticles | ISO 19007:2018 specifies a method for evaluating the effects of nano-objects and their aggregates... | a. Standard | Health, Safety, and Environment | Biological testing laboratories. | 2019-06-14 | ||
2 | International Organization for Standardization | ISO | 18827 | ESR as a method for measuring ROS generated by metal oxide nanomaterials | This technical specification will provide guidelines for the toxicity of ZnO nanomaterials in... | Electronic spin resonance; ESR; Reactive Oxygen Species (ROS); spin-trap agents | a. Standard | Health, Safety, and Environment | NA | 2017-06-15 |